STP portfast trunk command changes in s1e2

[mcgrathd]

I noticed that in the s1e2 chapter of ccna-prep that Step 4 is still written as:

 DLS1(config)# interface G0/3
    DLS1(config-if)# spanning-tree portfast trunk 
    %Warning: portfast should only be enabled on ports connected to a single
     host. Connecting hubs, concentrators, switches, bridges, etc... to this
     interface  when portfast is enabled, can cause temporary bridging loops.
     Use with CAUTION

The current CML version 2.9.1+build.7 I am running appears to be shipping a version of the switch running:

DLS1(config-if)#do show ver
Cisco IOS Software, vios_l2 Software (vios_l2-ADVENTERPRISEK9-M), Experimental Version 15.2(20200924:215240) [sweickge-sep24-2020-l2iol-release 135]
Copyright (c) 1986-2020 by Cisco Systems, Inc.
Compiled Tue 29-Sep-20 11:53 by sweickge

This appears to be an updated IOS since the PDF was made that now expects the newer command syntax:

DLS1(config-if)# spanning-tree portfast edge trunk