PureThermal 2

[rvegele]

Hi,

I'm getting Stream failed; Result =-1 when trying to start a transmission for a purethermal camera.
firmware 1.3

Any help is much appreciated.

Thanks

[Peter-St]

Hi

Pure Thermal support should work with the latest update.

[juice77ooO]

I have used the latest version, but the problem is the same.Any help is much appreciated. Thank u.

[Peter-St]

Hi,

any more Infos would be appreciated:

Have you tested your camera on a linux pc? Have you read out the camera spezifications there?

Which steps have you performed with my app. Have you set up the uvc camera values correctly?
Have you tried to run the app with android studio and looked to the debug output?

Plz some more informations.
So far, Peter

[juice77ooO]

Hi,

any more Infos would be appreciated:

Have you tested your camera on a linux pc? Have you read out the camera spezifications there?

Which steps have you performed with my app. Have you set up the uvc camera values correctly? Have you tried to run the app with android studio and looked to the debug output?

Plz some more informations. So far, Peter

hi!

I just set wrong values. Now i can start camera.

thank u!!!!!!!!!!!!!!!!!!!!!!!!!!

[rvegele]

Hi,
any more Infos would be appreciated:
Have you tested your camera on a linux pc? Have you read out the camera spezifications there?
Which steps have you performed with my app. Have you set up the uvc camera values correctly? Have you tried to run the app with android studio and looked to the debug output?
Plz some more informations. So far, Peter

hi!

I just set wrong values. Now i can start camera.

thank u!!!!!!!!!!!!!!!!!!!!!!!!!!

Hi, what values did you end up using?

[juice77ooO]

Hi,
any more Infos would be appreciated:
Have you tested your camera on a linux pc? Have you read out the camera spezifications there?
Which steps have you performed with my app. Have you set up the uvc camera values correctly? Have you tried to run the app with android studio and looked to the debug output?
Plz some more informations. So far, Peter

hi!
I just set wrong values. Now i can start camera.
thank u!!!!!!!!!!!!!!!!!!!!!!!!!!

Hi, what values did you end up using?

Maybe you can input "lsusb -v | less" with terminal, then will see your camera values.