Incomplete merge conflicts

[krissrex]

docs/docs/Panda_Breath.md

Lines 154 to 174 in 1b5b40b

	<<<<<<< HEAD
	4. Place the Panda Breath at the very back of the Snapmaker U1 chamber, pressing it slightly against the transparent rear panel.
	<<<<<<< HEAD
	=======
	>>>>>>> 2840f704c (modify panda breath en and zh serial error)
	>Important: Ensure the bottom of the Panda Breath is suspended—do not let it press on the cable.
	=======
	4. Position the Module<br>Place the Panda Breath at the very back of the Snapmaker U1 chamber, gently pressing it against the transparent rear panel.<br>
	> Important: Ensure the bottom of the Panda Breath is suspended—do not let it press on the cable.
	>>>>>>> 0e7cba632bde2614712ad46fb294834edddc4f5d
	<img src=img/PandaBreath/U1install06.jpg width="500"/>
	<img src=img/PandaBreath/U1install07.jpg width="500"/>
	<<<<<<< HEAD
	5. Once position is confirmed, fully tighten all 4 screws on the left mounting bracket.
	=======
	5. Secure the Installation<br>Once the module is correctly positioned, fully tighten all four screws on the left mounting bracket to secure it in place.
	>>>>>>> 0e7cba632bde2614712ad46fb294834edddc4f5d