Revise startup sequence - battery in rear etc.

[jjblum]

--> INSERT CONNECT EXTERNAL LOOPBACK CABLES IF YOU HAVE OLD EBOARD

1. Turn on the phone and tablet
   

2. Open the white housing --> CHANGE TO OPEN REAR LID
   

3. Plug in the LiPo battery
   

--> INSERT TURN ON BLUEBOX SWITCH
4. Turn on the e-board
5. Connect the phone and tablet to the WiFi generated by the boat
6. Open the phone app
7. Phone app: Set vehicle and sensor options
8. Phone app: Start the app
9. Phone app: Observe IP address
10. Phone app: Calibrate compass
11. Plug in the phone
12. Phone app: Press (and hold for ~ 1 second) the set sensor types button
13. Place the phone on the port wall of the white housing
14. Turn on the BlueBox --> REMOVE THIS, IT IS INSERTED ABOVE
15. Verify that the phone stops warning about missing BlueBox data
16. Open the tablet app
17. Tablet app: Connect the tablet to the phone with the IP address
18. Tablet app: Verify that sensor data appears
19. Close the white housing --> SWITCH WITH USE RC CONTROLLER TO VERIFY DIRECTION
--> ALSO CHANE NAME TO EXPANSION HOUSING
20. Use RC controller to verify correct left/right turning direction --> SWITCH WITH CLOSE WHITE HOUSING
21. Verify that the rear compartment is closed
22. If you are using an airboat, Tighten airfan assembly bolts
23. Launch the boat