Sinric Pro temperature sensor refreshing issue

[pedrofnm]

Hello,
I have 3 temperature/humidity sensors in my sinric Pro account and I'm planning getting 2 more but I'm facing an issue that I can't get througt. The thing is the sensors works great but it supposed to update temp/humidity every minute and it's not happening. Sometimes it updates kinda randomly but other times it doesn't unless I unplug it and plug it back on. What I'm trying to say is that it only works well when I restart the sensor. I'm using the code provided by sinric Pro (only edited ssid, pass, device ID, pin number, etc.) And I'm using an esp 01 s dht11 sensor module. All the sensors are close to the router so I don't know what else might be causing this problem. I even uncommented Enable_debug in the code to see if something changes but nothing. I'm not sure if the code uses deep sleep or something and it won't update because of that... Anyway I have a picture of my sinric Pro dashboard showing that some sensors stays hours without updating even if I refresh the dashboard. I hope you can help me on this.

Thanks

[kakopappa]

Have you tried disabling the sleep? esp8266/Arduino#460 Also try adding remoteddebug https://github.com/JoaoLopesF/RemoteDebug And monitoring the serial output over time

…

On Tue, 25 May 2021 at 6:34 PM pedrofnm ***@***.***> wrote: Hello, I have 3 temperature/humidity sensors in my sinric Pro account and I'm planning getting 2 more but I'm facing an issue that I can't get througt. The thing is the sensors works great but it supposed to update temp/humidity every minute and it's not happening. Sometimes it updates kinda randomly but other times it doesn't unless I unplug it and plug it back on. What I'm trying to say is that it only works well when I restart the sensor. I'm using the code provided by sinric Pro (only edited ssid, pass, device ID, pin number, etc.) And I'm using an esp 01 s dht11 sensor module. All the sensors are close to the router so I don't know what else might be causing this problem. I even uncommented Enable_debug in the code to see if something changes but nothing. I'm not sure if the code uses deep sleep or something and it won't update because of that... Anyway I have a picture of my sinric Pro dashboard showing that some sensors stays hours without updating even if I refresh the dashboard. I hope you can help me on this. Thanks [image: Screenshot_20210525-120231] <https://user-images.githubusercontent.com/64743076/119490795-283eb480-bd55-11eb-9c09-3e0ba4273959.png> — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#9>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABZAZZTLJNCZWNI3IEX3TXTTPODMZANCNFSM45PE7VSA> .

[pedrofnm]

Well I think I found what's going on. It only updates in the dashboard if a temp/humidity value is changed. If the values stays the same, it doesn't update in the dashboard since the temp/humidity values don't change much in a closed room. I have tried to point a heater to the sensor and it automatically updated the raised temp. Until this, the sensor was like 1 hour without updating because the temperature/humidity values hadnt changed in that sensor. And I have done this to the other sensors and updated automatically too.

[pedrofnm]

I guess I misunderstood how the graph in the dashboard works. I thought it would update every minute the temperature/humidity even if was the same values.

[kakopappa]

If you have used the sample sketch, it does not send the same value again and again
https://github.com/sinricpro/esp8266-esp32-sdk/blob/master/examples/temperaturesensor/temperaturesensor.ino#L107

[pedrofnm]

Yeah I did used the sample sketch. Next time I should pay more attention to the code :/
Thanks for your support