Same-net traces not visually merged in schematic (JP6→R1 connection missing)

[Prachi-kushwaha]

When two traces belong to the same net and are aligned (same X or same Y), the schematic solver does not visually merge them into a single continuous wire.

Expected:
A continuous visible connection from .JP6 > .pin2 → .R1 > .pin2

Actual:
Only two short traces are drawn — the segment between .JP6 and .R1 is missing in the schematic view

[rushabhcodes]

@Prachi-kushwaha
Can you share the JSON or schematic source that produces this missing-segment behavior?

[Prachi-kushwaha]

@rushabhcodes In core repo - tests->repros->repro49-same-net-not-combine.test.tsx

[rushabhcodes]

@Prachi-kushwaha I think I’ve identified the problem. It works fine as long as the schX value between the two components is less than on equal to 3.3
A temporary fix is to set JP6 > schX = -2 or lower.
It also works if you set border > schMaxTraceDistance={2.9} or higher.
We’ll need to work on a permanent fix for this.

[rushabhcodes]

@seveibar The issue is that if the trace distance exceeds the default limit, the system breaks — likely due to the schX constraint not being properly handled beyond that threshold.

[rushabhcodes]

I would like to contribute — can you please guide me on how to get started?